Quick answer
Add the average watts of everything that must run, multiply by the hours of outage you want to cover, and divide by 0.85 for inverter losses. A CPAP, Wi-Fi, lights and phones for one night is about 0.5 to 1kWh (Elite 100 V2). Add a fridge for a day and you need about 2kWh (Elite 200 V2). Add a gas furnace blower overnight and plan on 3kWh (Elite 300) or a home battery.
Typical watts for common outage loads
| Device | Running watts (typical) | Average over time | Notes |
|---|---|---|---|
| Phone charging | 5 to 15W | small | A full charge is about 10 to 20Wh |
| Wi-Fi router and modem | 10 to 25W | 10 to 25W | Runs 24/7, so it adds up |
| LED bulb | 8 to 12W | as used | |
| CPAP | 30 to 60W (humidifier off) | 30 to 100W | Humidifier doubles it |
| Laptop | 30 to 70W | as used | |
| Refrigerator | 100 to 250W | 40 to 75W | Compressor cycles |
| Chest freezer | 60 to 150W | 25 to 60W | Very efficient |
| Gas furnace blower | 300 to 800W | 100 to 400W | Depends on cold and motor |
| Sump pump, 1/3 HP | about 800W | depends on rain | Startup surge 2 to 3x |
| Microwave | 1,000 to 1,500W | short bursts | |
| Space heater | 1,500W high, 750W low | 1,500W | Drains batteries fast |
| Well pump | 1,000 to 2,000W | depends | Often 240V |
The formula
Runtime (hours) = battery Wh x 0.85 ÷ average watts. The 0.85 covers inverter and conversion losses; BLUETTI's own runtime formula in its FAQs also accounts for depth of discharge and standby use. Output (W) must also be higher than the biggest single load, including motor startup.
Pick by outage and household
| You need to run | For | Battery | Station |
|---|---|---|---|
| Phones, Wi-Fi, lights | 1 night | about 300Wh | Elite 30 V2 (288Wh) |
| CPAP + Wi-Fi + lights | 1 to 2 nights | about 1kWh | AC70 (768Wh) or Elite 100 V2 (1,024Wh) |
| Fridge + CPAP + Wi-Fi | about 1 day | about 2kWh | Elite 200 V2 (2,080Wh) or FridgePower (2,016Wh) |
| Furnace blower + fridge | 1 night | 2 to 3kWh | Elite 300 (3,014Wh) |
| Several circuits, 240V well pump | Multi-day | 3kWh and up, expandable | Apex 300 or AC300 + B300 with a transfer switch |
BLUETTI lineup at a glance
| Station | Capacity | Output | Best for |
|---|---|---|---|
| Elite 30 V2 | 288Wh | 600W | A small, silent station for phones, a router, lights or a CPAP without the humidifier. |
| AC70 | 768Wh | 1,000W | A light middle option for a CPAP, router, lights and phones over a long night. |
| Elite 100 V2 | 1,024Wh | 1,800W | The best all-rounder for most outages: CPAP, router, lights, phones and short fridge runs, quiet enough for a bedroom. |
| AC180 | 1,152Wh | 1,800W | A proven 1kWh class station that recharges fast between rolling outages. |
| Elite 200 V2 | 2,080Wh | 2,600W | Enough capacity to keep a refrigerator, furnace blower or sump pump going through a long night. |
| AC200L | 2,048Wh | 2,400W | A 2kWh station you can grow later with expansion batteries as your outage plan gets bigger. |
| FridgePower | 2,016Wh | 1,800W | Built for one job: the fridge switches to battery the moment the grid drops, with no electrician. |
| Elite 300 | 3,014Wh | 2,400W | 3kWh in a 2kWh size. Runs the fridge, lights, furnace blower and phones through a full day and night. |
| Apex 300 | 2,765Wh | 3,840W | Home backup that grows with you, including 240V loads like a well pump when it is wired in by an electrician. |
| AC300 + B300 | Modular | 3,000W | A modular home battery system for households that want to plan around multi-day outages. |

BLUETTI Elite 100 V2
The best all-rounder for most outages: CPAP, router, lights, phones and short fridge runs, quiet enough for a bedroom.
1,024Wh LiFePO4 battery · 1,800W output, 2,700W lifting mode
See it at BLUETTI
BLUETTI Elite 200 V2
Enough capacity to keep a refrigerator, furnace blower or sump pump going through a long night.
2,080Wh LiFePO4 battery · 2,600W output, 3,900W lifting mode
See it at BLUETTI
BLUETTI Elite 300
3kWh in a 2kWh size. Runs the fridge, lights, furnace blower and phones through a full day and night.
3,014Wh LiFePO4 battery · 2,400W output, 4,800W lifting mode
See it at BLUETTI
BLUETTI Apex 300
Home backup that grows with you, including 240V loads like a well pump when it is wired in by an electrician.
2,764.8Wh LiFePO4, expandable · 3,840W output, 120V and 240V
See it at BLUETTICold-weather notes
- BLUETTI advises against recharging its LiFePO4 stations below freezing. Keep them in the heated part of the house.
- Keep stations charged to the level the manual recommends for storage, and top them off to 100% when a storm is forecast.
- A UPS or pass-through setup (10 to 20ms switchover on most BLUETTI models) lets the station take over automatically.
Sizing guides
Backup powerHow long will a power station run a refrigerator?Runtime tables for a full-size fridge on a 1kWh, 2kWh and 3kWh power station, how to read your EnergyGuide label, and...
Backup powerPower station for a CPAP: how many nights will it last?How many nights a CPAP runs on a 288Wh, 768Wh or 1kWh power station, with and without the humidifier, plus the 10ms UPS...
Backup powerCan a power station run a space heater?Yes, but not for long. Runtime for a 1,500W heater on 1kWh to 3kWh stations, and the warmer, smarter way to stay heated...
Backup powerCan a power station run a gas furnace?Yes: a gas furnace only needs electricity for the blower and controls. Typical watts, runtime on 2kWh and 3kWh...
Backup powerHow long will a power station run a sump pump?Sump pump watts, startup surge and duty cycle, with runtime tables for 2kWh and 3kWh stations. Keep the basement dry...
Backup powerPower station vs generator for winter power outagesIndoor safety, noise, fuel, runtime and cost compared. Why many households pair a power station for overnight with an...Our picks

BLUETTI Elite 100 V2
The best all-rounder for most outages: CPAP, router, lights, phones and short fridge runs, quiet enough for a bedroom.
1,024Wh LiFePO4 battery · 1,800W output, 2,700W lifting mode
See it at BLUETTI
BLUETTI Elite 200 V2
Enough capacity to keep a refrigerator, furnace blower or sump pump going through a long night.
2,080Wh LiFePO4 battery · 2,600W output, 3,900W lifting mode
See it at BLUETTI
BLUETTI Elite 300
3kWh in a 2kWh size. Runs the fridge, lights, furnace blower and phones through a full day and night.
3,014Wh LiFePO4 battery · 2,400W output, 4,800W lifting mode
See it at BLUETTI
BLUETTI FridgePower
Built for one job: the fridge switches to battery the moment the grid drops, with no electrician.
2,016Wh LiFePO4 battery · 1,800W output, 3,600W surge
See it at BLUETTI
BLUETTI Apex 300
Home backup that grows with you, including 240V loads like a well pump when it is wired in by an electrician.
2,764.8Wh LiFePO4, expandable · 3,840W output, 120V and 240V
See it at BLUETTI
BLUETTI 350W Solar Panel
Refills a power station on sunny days between storms, which matters when restoration takes days.
350W folding solar panel · Recharges a BLUETTI station when the grid stays down
See it at BLUETTIP3 Kill A Watt Electricity Usage Monitor
Measures exactly what your fridge or CPAP draws so you can size the battery.
Check price on AmazonMore outage types
PillarWinter Storms and Nor'eastersNor'easters, heavy wet snow and cold snaps from the Mid-Atlantic to Maine.
PillarIce StormsFreezing rain that brings down lines across the South, Plains, Midwest and Northeast.
PillarBlizzards and Lake-Effect SnowWhiteouts and snow bands from the Great Lakes to the northern Plains.
PillarWest Coast Windstorms and Atmospheric RiversPacific windstorms, bomb cyclones and atmospheric rivers from California to Washington.
PillarWildfire Power Shutoffs (PSPS)Planned Public Safety Power Shutoffs during fire weather in California and the West.
PillarTornado and Derecho SeasonSpring and summer severe storms across the Plains, Midwest and South.
PillarSummer Heat and Grid AlertsHeat waves, Flex Alerts in California and ERCOT conservation appeals in Texas.
PillarHurricanesOur original guides: kits, evacuation, generators, shutters and the first 72 hours.Sources
FAQ
What size power station do I need to run a refrigerator?
About 2kWh for a full day of a typical full-size fridge. 1kWh covers roughly half a day to most of a day.
How many watt-hours do I need for a power outage?
Add up the average watts of your must-run devices, multiply by the hours you want to cover, and divide by 0.85. Most homes land between 1 and 3kWh for a night to a day.
Is 1000Wh enough for a power outage?
For a CPAP, Wi-Fi, lights and phones for a night or two, yes. For a fridge plus a furnace blower, you will want 2 to 3kWh.