Quick answer
Without the heated humidifier, most CPAP machines draw roughly 30 to 60 watts, so a 1kWh station like the Elite 100 V2 runs about 2 to 3 nights. With the humidifier and heated tube, plan on one night per kWh or less. The Elite 100 V2 also switches over in 10ms, so therapy does not stop when the power cuts out.
How much power does a CPAP use?
The power brick on your CPAP shows its maximum (often 65 to 90 watts), but the machine rarely runs at that. Real draw depends on pressure setting and, above all, the heated humidifier and heated tubing, which can double or triple consumption.
| Setup | Typical average draw | Energy for an 8 hour night |
|---|---|---|
| CPAP only, humidifier off | 30 to 60W | 240 to 480Wh |
| CPAP with heated humidifier | 60 to 100W | 480 to 800Wh |
| CPAP with humidifier and heated tube | 80 to 120W | 640 to 960Wh |
The best way to know: plug the CPAP into a Kill A Watt meter for one normal night and read the kWh in the morning.
Nights per station
| Load (typical watts) | Elite 30 V2 (288Wh) | AC70 (768Wh) | Elite 100 V2 (1,024Wh) | Elite 200 V2 (2,080Wh) |
|---|---|---|---|---|
| CPAP only (40W) | 6.1 hr | 16 hr | 22 hr | 44 hr |
| CPAP + humidifier (80W) | 3.1 hr | 8.2 hr | 11 hr | 22 hr |
| CPAP + humidifier + heated tube (100W) | 2.4 hr | 6.5 hr | 8.7 hr | 18 hr |
Reading the table: the small Elite 30 V2 covers about one short night with the humidifier off. The Elite 100 V2 covers two to three nights without the humidifier, or about one night with it. If you live in a PSPS area or rural ice storm country where outages last days, the Elite 200 V2 gives you real breathing room, or pair any station with a solar panel.
Why the 10ms UPS matters
Most power stations can pass wall power through and take over when it fails. BLUETTI lists a 10ms switchover on the Elite 30 V2, Elite 100 V2 and Elite 300 (15ms on the Elite 200 V2). Leave the CPAP plugged into the station every night and an outage at 2 a.m. does not interrupt your therapy.
Stretch your battery
- Turn the humidifier off or down for the outage night. It is the biggest power draw.
- Use the DC power cord made for your CPAP model if one exists. It avoids inverter losses.
- Keep the station charged to 100% from late fall through winter, and in summer if you are in a PSPS zone.
- Recharge from the car (12V) or a solar panel if the outage stretches on.
Medical baseline and utility programs
If you rely on powered medical equipment, enroll with your utility. PG&E's Medical Baseline program, for example, adds extra alerts before a Public Safety Power Shutoff. Some utilities also offer battery programs for eligible customers. Talk to your doctor and CPAP supplier about your backup plan.
Smallest option
BLUETTI Elite 30 V2
For one night away from home or a short outage with the humidifier off: 288Wh, 600W, 10ms UPS, and light enough to carry with one hand.
See it at BLUETTICPAP backup checklist
- Measure your CPAP's real draw for one night
- Decide humidifier on or off for outages
- Buy the DC cord for your model if available
- Keep the station charged and the CPAP plugged into it nightly
- Enroll in your utility's medical baseline or critical care list
- Keep a battery headlamp at the bedside
Our picks for this outage

BLUETTI Elite 100 V2
The best all-rounder for most outages: CPAP, router, lights, phones and short fridge runs, quiet enough for a bedroom.
1,024Wh LiFePO4 battery · 1,800W output, 2,700W lifting mode
See it at BLUETTI
BLUETTI Elite 30 V2
A small, silent station for phones, a router, lights or a CPAP without the humidifier.
288Wh LiFePO4 battery · 600W output, 1,500W lifting mode
See it at BLUETTI
BLUETTI AC70
A light middle option for a CPAP, router, lights and phones over a long night.
768Wh LiFePO4 battery · 1,000W output, 2,000W lifting mode
See it at BLUETTI
BLUETTI Elite 200 V2
Enough capacity to keep a refrigerator, furnace blower or sump pump going through a long night.
2,080Wh LiFePO4 battery · 2,600W output, 3,900W lifting mode
See it at BLUETTI
BLUETTI 350W Solar Panel
Refills a power station on sunny days between storms, which matters when restoration takes days.
350W folding solar panel · Recharges a BLUETTI station when the grid stays down
See it at BLUETTIP3 Kill A Watt Electricity Usage Monitor
Measures exactly what your fridge or CPAP draws so you can size the battery.
Check price on AmazonRechargeable LED Headlamp
Hands-free light that recharges from any power station USB port.
Check price on AmazonSources
FAQ
Can a power station run a CPAP all night?
Yes. A 1kWh station runs most CPAPs all night even with the humidifier on, and two to three nights with it off. A small 288Wh station covers about one night with the humidifier off.
Do I need a pure sine wave power station for a CPAP?
Yes, use a pure sine wave inverter. BLUETTI stations output pure sine wave AC, and the DC cord for your CPAP is even more efficient.
Is a power station or a generator better for a CPAP?
For overnight use indoors, a power station. It is silent, has no exhaust, and can switch over automatically. A generator must run outside at least 20 feet from the house, per CPSC.
How do I know how many watts my CPAP uses?
Measure it with a plug-in watt meter for one night, or check your manufacturer's power specs. The rating on the power supply is a maximum, not the average.
